Cutter Suction Dredger works

Generally speaking, the work of Cutter Suction Dredger was to clean the silt in the fan-shaped area. Cutter Suction Dredger had two transverse hoist, and after the area of the reamer was cleaned up, the transverse hoist on one side was started to make the reamer and its big arm rotate to one side for dredging silt. After the completion of cleaning on this side, the transverse winch on the other side was started again to make the Cutter Suction Dredger rotate to the other side and clean the silt on the other side.

After the dredging was completed, the whole area formed a fan-shaped area, and then drove the Cutter Suction Dredger to the front to clean the next fan-shaped area, which was the general working state of the Cutter Suction Dredger. When cleaning the silt, the other parts of the Cutter Suction Dredger are needed to work together, the reamer agitate the silt at the bottom of the river, and the mud pump will at the same time be mixed with water into a certain proportion of the material pumped into the pump, and then discharged to the bank through the pipeline.